![]() NeoRouter Client: Works as Application Mode ![]() You can use the link to verify your open port: If you are running a NeoRouter Server on a computer or device behind a NAT, you may need to change the router configuration to either enable the UPnP or set the port forwarding. If you are running the NeoRouter Server in-a-box and put the router on the Internet, you don’t need to do anything. NeoRouter clients do not require any port opened to the Internet. When you install the NeoRouter Server, you need to make sure a listening port (default port 32976 and TCP protocol) can be access from the Internet. To configure on Linux: sudo nrclientcmd -setconnĬhoose your connection type (sample output): Please choose from the following option list:ġ Create a direct peer-to-peer UDP connectionĢ Create a direct peer-to-peer TCP connectionįor server ONLY. Useful when your network is not stable or your router uses special MTU value. If your router or firewall block UDP packets or your network if not stable.įorce clients to use server to relay data. TCP – Create a direct peer-to-peear TCP connection.This option is recommended for most home users. UDP – Create a direct peer-to-peear UDP connection.This option allows user to specify the connection type between this computer and its peers. NeoRouter Client: Configure P2P Connection Note: Change 192.168.0.1 and 80, respectively, to your proxy IP server and port.Īfter running the command above, the configuration Proxy.xml file is generated under the folder “/usr/local/ZebraNetworkSystems/NeoRouter”. To set proxy without autentication: sudo nrclientcmd -setproxy http,192.168.0.1,80,noauth Please choose from the following proxy option list: ![]() If the client host is behind a web proxy, you need to set a proxy server configuration: sudo nrclientcmd -setproxyįollow the steps to configure the proxy (sample output): NeoRouter Free
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |